This guide will teach you how to connect Goldshell miner with Wifi with and without a cable.
In order to make more occasions easier, Goldshell has updated and added the WIFI function of miners. Wi-Fi and/or cable connections to networks are both options.
Table of Contents
Method 1: Connect Goldshell Miner With Network Cable:
Dashboard method 1: Go to find.goldshell.com, select the gear icon on the right, and then select the Goldshell miner dashboard.
Wi-Fi can be connected using a network security key by clicking [System] and [WIFI Settings].
Wait until connect it successfully. See below
When connecting to WiFi successfully, a link icon will show up in the WIFI setting head. This icon indicates that the miner has been assigned a new IP address. When the network cable is unplugged, you can still access this IP page.
Add the pool, connect, and then begin mining.
Method 2: Connect Goldshell Miner With WIFI
When you turn on the miner without a cable, a free WiFi signal is available. Connect to this WIFI via using other devices (mobile phones, computers), Open the browser and input fixed address 192.168.0.1, then enter to dashboard successfully.
Click to [System] and [WIFI settings], connect WIFI with password.
Note: Enter the correct WIFI password
As soon as the miner connected to WiFi, check the status on the dashboard.
Make sure the router and the miner are on the same local network. Visit find.goldshell.com or use Enter the WIFI setting dashboard by using the Yotta BC software and the IP button.
Note: If you are unable to open the dashboard, the WiFi password was incorrect. Repeat the above procedure after pressing the RESET button on the miner to restore the factory settings. Alternatively, use method 1 to connect the network cable and configure WIFI.
When you check it in the WIFI dashboard page, you will see the connected status.
Tips: How to Disconnect WIFI
Resetting the miner would be helpful if you wanted to disable the WiFi. (Press the reset button for about 10 seconds, the indicators will be lighting, wait until they shut down) Then plug in the Ethernet cable to connect miner.
If that doesn’t work, try first plugging in the Ethernet cable, then disable the WiFi from the System tab of the miner dashboard, and finally reset the device.
